Section 912
FILSER TRT 600 Transponder
912 - 8 Page Date: 31. January 2006
Pilot´s Operating Handbook
EXTRA 300S
To meet ICAO specifications the TRT 600 uses an external memory inside the aircraft connector
housing of the cable set, which is a part of the aircraft. Because this cable is installed permanent
into the aircraft, a change of the transponder will not affect the aircraft address and the Flight ID.
In the event there is a Cradle error, (empty memory or data error) 'OUT OF ORDER' will be
displayed .The first line shows which kind of error is present:
'Cradle OFF' displayed means no or defective data.
'Cradle Data' displayed means digital checksum error.
After a few seconds the display shows normal operating condition but with inhibited Mode S. The
transponder will work with Mode A/C only. You will need to consult an authorized service station
to enter the ICAO aircraft address (see TRT 600 Installation Manual). Please consult your
airworthiness authority for national procedures.
NOTE
If no valid ICAO 24 bit aircraft address is programmed to the unit or if the memory is
inoperative the transponder will inhibit the Mode S functions. In this case only Mode A/C
function will be available.
912.2 LIMITATIONS
Not applicable
912.3 EMERGENCY PROCEDURES
The following emergency codes should be noted:
7500 Hijacking
7600 Loss of communication
7700 Emergency
912.4 NORMAL PROCEDURES
Not applicable
912.5 PERFORMANCE
Not applicable
To Next Page
Loading...
