Table 8: Hardware requirements for pole installation (continued)
Quantity Item
4 M3 screws with nuts and washers to attach the WS-
MBO-POLE01 bracket to the MBO-ART02 articulating
mounting bracket
2 Cable clamps
Note
You must provide stainless-steel cable clamps. The band must be 0.5 in. (12.7
mm) wide.
Procedure
1. Attach the MBO-ART02 articulating mounting bracket to the access point using two
M6 hex-head screws.
Install the Access Point
Install the Access Point on a Pole Using MBO-ART02
Articulating Mounting Bracket and POLE01 Bracket
ExtremeWireless™ AP560h Access Point 27
To Next Page
Loading...
