2. Attach the pole bracket part of the KT-147407-02 bracket to the other end of the
KT-150173-01 bracket using two hex-head M12 stainless-steel screws and two hex-
head M12 stainless-steel nuts.
3. Attach the pole bracket to a pole by following steps 5, 6, and 7.
Secure the Access Point after Installation
Details about installing a security cable on the access point after installation.
Before You Begin
The following hardware must be supplied by the user for safety cable installation:
• A 3 mm diameter security cable
• Lock to secure the ends of the security cable
About This Task
You can secure the access point to the mounting environment using a 3 mm diameter
safety cable. The safety cable is used to enhance the physical security of the access
point after installation.
Secure the Access Point after Installation Install the Access Point
34 ExtremeWireless™ AP560h Access Point
To Next Page
Loading...
