7. Insert the ends of the cable clamps around the pole and tighten the clamp screws to
a torque of 11 in-lbs.
Mount the Access Point to a Pole using the Pole Part of the KT-147407-02 Bracket
Before You Begin
The following hardware is required for pole installation using KT-147407-02 pole bracket
part to the access point:
• Pole part of the KT-147407-02 bracket
• Four M6 screws
• Two 0.5 in. wide stainless-steel cable clamps
• One access point
About This Task
The pole part of the KT-147407-02 bracket is attached to the access point for pole
installation. To mount the access point to a pole using the KT-147407-02 pole bracket
part:
Procedure
1. Attach the pole part of the KT-147407-02 bracket to the access point using four M6
screws.
Align the four hinges of the pole part of the KT-147407-02 bracket against the holes
on the access point to attach the M6 screws.
2. Attach the pole bracket to a pole by following steps 5, 6, and 7.
Mount the Access Point to a Pole using the Pole Part of the KT-147407-02 Bracket and the
KT-150173-01 Extension Arm
Before You Begin
The following hardware is required for pole installation using KT-147407-02 pole bracket
part and the KT-150173-01 extension arm:
• Pole part of the KT-147407-02 bracket
• KT-150173-01 extension arm
• Four M6 screws
• Two hex-head M12 stainless-steel screws
• Two hex-head M12 stainless-steel nuts
• Two 0.5 in. wide stainless-steel cable clamps
• One access point
About This Task
The extension arm is used with the pole part of the KT-147407-02 bracket on the access
point for pole installation. To mount the access point to a pole using the KT-147407-02
pole bracket part and the KT-150173-01 extension arm:
Procedure
1. Attach the KT-150173-01 extension arm to the access point using two M6 screws.
Install the Access Point
Install the Access Point on a Pole Using KT-147407-02
Bracket Parts and KT-150173-01 Extension Arm
ExtremeWireless™ AP560h Access Point 33
To Next Page
Loading...
