The following hardware is required to install the AP560i access point on a pole:
• Flat part of the KT-147407-02 bracket
• Pole part of the KT-147407-02 bracket
• 1-axis tilt bracket
• Six M6 screws
• Two hex-head M12 stainless-steel screws
• Two hex-heads M12 stainless-steel nuts
• Two M12 screws
• Two M12 hex nuts
• 0.5 in. wide stainless-steel cable clamps
• KT-150173-01 extension arm
Note
You must provide M6 hex-head screws and screw-in anchors.
Note
The cable glands must face down when you install the access point on a pole.
Install the Access Point on a Pole Using MBO-ART02 Articulating Mounting Bracket
and POLE01 Bracket
About This Task
Attach the access point to a pole using the WS-MBO-POLE01 bracket on MBO-ART02
articulating mounting bracket.
Note
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It
is replaced by the MBO-ART03 bracket.
The 30520 wireless mounting kit is End of Sale (EOS).
For more information, see End of Sale and End Service Life.
Table 8: Hardware requirements for pole installation
Quantity Item
1 Access point
1 MBO-ART02 articulating mounting bracket
2 M6 hex-head screws to attach the MBO-ART02 to the
access point
1 WS-MBO-POLE01 bracket
Install the Access Point on a Pole Using MBO-ART02
Articulating Mounting Bracket and POLE01 Bracket Install the Access Point
26 ExtremeWireless™ AP560h Access Point
To Next Page
Loading...
