Extreme Networks ExtremeWireless AP560h - Install the Access Point on a Pole Using KT-147407-02 Bracket Parts

5. Tighten the cable clamp screw clockwise, tightening the band around the pole.
Figure 9: Tightening the cable clamps on the POLE01 bracket
Install the Access Point on a Pole Using KT-147407-02 Bracket Parts
Before You Begin
The following hardware is required for pole installation using KT-147407-02 bracket
parts:
• Flat part of the KT-147407-02 bracket
• 1-axis tilt part of the KT-147407-02 bracket
• Pole part of the KT-147407-02 bracket
• Four M6 screws
• Two hex-head M12 stainless-steel screws
• Two hex-head M12 stainless-steel nuts
• Two 0.5 in. wide stainless-steel cable clamps
• One access point
Install the Access Point on a Pole Using KT-147407-02
Bracket Parts Install the Access Point
30 ExtremeWireless™ AP560h Access Point