Extreme Networks ExtremeWireless AP560h - Power or Pressure Washing Guidelines

Procedure
1. Insert the safety cable through the security cable hole on the metal base of the
access point.
Figure 11: Security cable hole on the access point
Callout
Description
1 Security cable hole
2. Push the cable through the security hole until you see it come out on the other side
of the metal base.
3. Insert a lock through the looped ends of the cable and lock it in place.
Power or Pressure Washing Guidelines
Details about how to safely pressure wash the surface around the access point.
Before You Begin
Ensure that your pressure washing equipment fullls the following specications:
• Pressure washer Pounds per Square Inch (PSI) must be less than 4000.
• Do not use a nozzle with less than 15-degree washer tip.
• The pressure washing nozzle must be at least 24 in. away from the access point.
Cleaning solution specications:
• Use only commercially available cleaning agents and solvents to clean the access
point.
Install the Access Point Power or Pressure Washing Guidelines
ExtremeWireless™ AP560h Access Point 35