Extreme Networks ExtremeWireless AP560h - Install the Access Point Using KT-147407-02 Bracket Parts and KT-150173-01; Extension Arm

Install the Access Point Using KT-147407-02 Bracket Parts and KT-150173-01
Extension Arm
Before You Begin
The hardware required for installation:
• Flat part of the KT-147407-02 bracket
• 1-axis tilt part of the KT-147407-02 bracket
• KT-150173-01 extension arm
• One access point
Figure 7: KT-150173-01 extension arm
About This Task
The KT-150173-01 extension arm is used in combination with the wall and pole bracket
parts of the KT-147407-02 bracket.
Procedure
1. Attach the at part of the KT-147407-02 bracket to the access point using two M6
screws.
2. Place the at part of the KT-147407-02 bracket inside the 1-axis tilt bracket, and
attach the 1-axis tilt bracket to the at bracket using four M6 screws.
Install the Access Point Using KT-147407-02 Bracket
Parts and KT-150173-01 Extension Arm Install the Access Point
24 ExtremeWireless™ AP560h Access Point