Install the Access Point on a Wall Using MBO-ART02 Articulating Mounting Bracket
About This Task
Note
The MBO-ART02 wall mount bracket is End of Sale (EOS) as of January, 2023. It
is replaced by the MBO-ART03 bracket.
For more information, see End of Sale and End Service Life.
Table 7: Hardware requirements for MBO-ART02 articulating mounting bracket
wall installation
Quantity Item
1 Access point
1 MBO-ART02 articulating mounting bracket
6 M6 hex-head screws
Two M6 hex-head screws to attach the MBO-ART02 to
the access point.
Four M6 hex-head screws to attach the MBO-ART02
bracket to the wall.
Note
When using the MBO-ART02 articulating mounting bracket, set the minimum
downward tilt to less than 20 degrees to prevent water ingress.
To install the access point on a wall:
Install the Access Point
Install the Access Point on a Wall Using MBO-ART02
Articulating Mounting Bracket
ExtremeWireless™ AP560h Access Point 19
To Next Page
Loading...
