Extreme Networks ExtremeWireless AP560h - Install the Access Point on a Wall or Flat Surface Using the KT-147407-02 Bracket Parts

Install the Access Point on a Wall or Flat Surface Using the KT-147407-02 Bracket
Parts
Before You Begin
Hardware requirements for a wall or at surface installation:
• Flat part of the KT-147407-02 bracket
• 1-axis tilt part of the KT-147407-02 bracket
• One access point
• Six M6 screws
• Four M6 headsize screws
Figure 5: Flat part of the KT-147407-02 bracket
Install the Access Point on a Wall or Flat Surface Using
the KT-147407-02 Bracket Parts Install the Access Point
22 ExtremeWireless™ AP560h Access Point