3. Attach both the cable clamps to the WS-MBO-POLE01 bracket.
Open the cable clamp by turning a at bladed screwdriver counterclockwise. Then
insert the non-clamp end into the pole bracket through the holes.
4. Put the metal band around the pole and attach the WS-MBO-POLE01 bracket to the
pole.
Figure 8: Attaching the cable clamps to the pole
Install the Access Point
Install the Access Point on a Pole Using MBO-ART02
Articulating Mounting Bracket and POLE01 Bracket
ExtremeWireless™ AP560h Access Point 29
To Next Page
Loading...
