Command and Response Table for Matrix Switcher Commands (continued)
DTP CrossPoint 4K Series Matrix Switchers • Programming Guide 69
Command Function
SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional description
RS-232 Insertion Commands (continued)
Ethernet and serial port insert parameters
Set serial port parameters
EX4#
*
X4$
,
X4%
,
X4^
,
X4&
CP
}
Cpn
X4#
•Ccp
X4$
,
X4%
,
X4^
,
X4&]
Read serial port parameters
EX4#
CP
}
X4$
,
X4%
,
X4^
,
X4&]
Configure current port timeout
E
0*
X4*
TC
}
Pti0*
X4*]
Read current port timeout
E
0TC
} X4*]
Configure global IP port timeout
E
1*
X4*
TC
}
Pti1*
X4*]
Read global IP port timeout
E
1TC
} X4*]
Set UART start point
EX4(
MD
}
Pmd
X4(]
Sets the initial (lowest) port number for
the range of numbers assigned to the
serial port and UARTs.
Read UART start point
E
MD
} X4(]
NOTE: X4# = Port number 01 = Remote (RS-232) port
02 — 09 = UARTs 1 — 8 (DTP input and output ports)
X4$ = Baud rate 300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600, 14400, 19200,
28800, 38400, 57600, 115200 (default=9600)
X4% = Parity odd, even, none, mark, space (only the first letter required) (n = default)
X4^ = Data bits 7, 8
X4& = Stop bits 1, 2
X4* = Port timeout interval (in 10-second increments) 1 (= 10 seconds) - 65000 (default is 30 = 300 seconds = 5 minutes)
X4( = UART starting point The starting point (X4() is the rear panel Remote RS-232 port.
The next four positions (X4(
+1
through X4(
+4
) are DTP inputs.
The next four positions (X4(
+5
through X4(
+8
) are DTP outputs.
Default values: 2000 = Rear panel Remote (RS-232) port
2001 through 2004 = Input 7 through input 10
2005 through 2008 = Output 5 through output 8
To Next Page
