Extron electronics ShareLink Pro 500 - Page 25

ShareLink Pro 500 • Operation Using a Computer 18
1
Device Info — Use this panel to change the device hostname. Click Edit to enter a
new hostname, and click Save.
2
Device Status — Click Edit to change the device time, date, and time zone. Click
Sync to PC to automatically sync the device to the PC time zone.
3
Firmware — Use this panel to update the device firmware:
1. Click Select File to browse to the firmware file.
NOTE: The latest firmware file can be downloaded from the Extron website (see
Firmware Download on page 48).
2. Select the firmware file, and click Update.
4
Network Settings — Click Edit to change the device name and the network settings
(IP address, subnet, and gateway IP address) for the LAN port.
5
Roles and Permissions — Click Edit to change the following passwords:
NOTE: The factory configured password for all accounts have been set to the
device serial number. Passwords are case sensitive. Performing a Reset to
Factory Defaults (see page 7) sets the password to the defaults shown below.
• Admin password (default: extron) — This password is used for accessing the
admin page.
• Moderator password (default: moderate) — This password is required to
moderate a session.
• Participant password (default: no password) — This password is required to
participate in a session.
Enter and confirm the new password, and click Save.
6
LinkLicense — Use this panel to upload the LinkLicense file to the
ShareLink Pro 500. If a LinkLicense has been purchased, upload the file as follows:
a. Click Select File and browse to the LinkLicense (.ell) file on your computer.
b. Select the file, and click Add to upload the file.