Extron electronics SW HD 4K PLUS Series - Page 38

SW HD 4K PLUS Series • Remote Configuration and Control 30
Command
ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
IP Configuration (continued)
List all time zones
E*TZON
}
{Multiple
X3$
*
X3%]
}
View a list of available time zones
(
X3$
) and their descriptions (
X3%
).
Set time zone
EX3$
*TZON
}
Tzon•
X3$
*
X3%]
Set the time zone. The time zone
code (
X3$
) is followed by an
asterisk (*) in the response.
NOTE: Use the List all time zones command to determine the desired time zone code (
X3$
).
View current time zone
ETZON
}
X3$
*
X3%]
In verbose modes 2 and 3:
Tzon•
X3$
*
X3%]
View the set time zone
X3$
followed by zone description
X3%
.
KEY:
X3$
= Time zone code An acronym for a time zone (2-6 letters)
X3%
= Time zone description The UTC equivalent of a particular time zone as well as a general
description of the geographical area.
Passwords
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial number. In the
event of an absolute system reset, the passwords convert ot the default, which is no password.
Set administrator
password
24
EX2^
CA
}
Ipa•
X2^]
Set administrator password
X2^
.
Clear administrator
password
24
E
•CA
}
Ipa•
]
Remove the administrator
password.
View administrator
password
24
E
CA
} X2^]
In verbose modes 2 and 3:
Ipa
X2^]
View the administrator password.
For the view password command
only:
X2^
= **** if a password exists,
an empty line if no password
exists.
Set user password
14,24
EX2&
CU
}
Ipu•
X2&]
Set user password
X2&
.
Clear user password
24
E
•CU
}
Ipu•
]
Remove user password
X2&
.
View user password
24
E
CU
} X2&]
In verbose modes 2 and 3:
Ipu
X2&]
View the user password.
For the view password command
only:
X2&
= **** if a password exists,
an empty line if no password
exists.
KEY:
X2^
= Administrator level password
X2&
= User level password
NOTE: In response to the View administrator password and the View user password commands,
X2^
and
X2&
are displayed as **** if a password exists. An empty line is displayed if no password exists.