SW HD 4K PLUS Series • Remote Configuration and Control 31
Command
ASCII Command
(Host to Switcher)
Response
(Switcher to Host)
Additional Description
IP Configuration (continued)
Network Time Protocol (NTP)
Enable or disable NTP for
setting the time
24
EX@
NTEN
}
Nten
X@]
Enable or disable (
X@
) NTP to set
the unit time.
Sync NTP now
E
2NTEN
}
Nten2
]
Sync the NTP server to NTP.
View NTP status
E
NTEN
} X@]
In verbose modes 2 and 3:
Nten
X@]
View NTP Enabled or Disabled
status
X@
.
Set a single NTP IP
address
24
EX2!
NTIP
}
Ntip
X2!]
Set IP address
X2!
for one NTP
server.
Set multiple NTP IP
addresses
24
EX2!
*
X2!
*...*
X2!
NTIP
}
Set IP addresses (
X2!
) for
multiple NTP servers.
Ntip
X2!
*
X2!
*...*
X2!
NTIP
]
NOTE: Up to four NTP addresses, separated by *, can be set.
Clear all NTP IP addresses
24
E
•NTIP
}
NTIP
]
Remove all NTP server IP
addresses.
View NTP IP addresses
E
NTIP
} X2!
*
X2!
*...*
X2!]
In verbose modes 2 and 3:
Ntip
X2!
*
X2!
*...*
X2!
NTIP
]
KEY:
X@
= NTP status 0 = NTP disabled, 1 = NTP enabled
X2!
= NTP server IP address Format nnn.nnn.nnn.nnn
Configure Serial Port
Set serial port parameters
EX2(
*
X3)
,
X3!
,
X3@
,
X3#
CP
}
Cpn
X2(
•Ccp
X3)
,
X3!
,
X3@
,
X3#]
Set the parameters for serial port
X2(
.
View serial port parameters
EX!
CP
} X3)
,
X3!
,
X3@
,
X3#]
In verbose modes 2 and 3:
Cpn
X2(
•Ccp
X3)
,
X3!
,
X3@
,
X3#]
KEY:
X2(
= Serial port number Two ASCII characters, 00 not permitted.
X3)
= Baud rate
300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600 (default),
14400, 19200, 28800, 38400, 57600, or 115200
X3!
=
Parity
Odd, Even, None (default), Mark, Space (Use only the first letter.)
X3@
= Data bits 7 or 8 (default)
X3#
= Stop bits 1 (default) or 2
System Reboot
Reboot system (1)
E1BOOT
}
Boot1
]
Reboot the system.
A firmware update requires this
command to complete.
Reboot system (2)
E2BOOT
}
Boot2
]
Reboot the system.
Changes made to the IP address,
subnet mask, DHCP setting, or
gateway address do not take
effect until this command is
issued.
To Next Page
Loading...
