PATHWAY
®
Aluminum Wheelchair Ramp Kit Assembly Manual Page 39 of 40
1
9. MAINTENANCE AND SAFETY
9.1. PERIODIC MAINTENANCE AND SAFETY
9.1.1.
Always exercise caution when handling, assembling, and or using the system. Proper
maintenance and upkeep of the ramp surface is vital.
9.1.2.
If needed, use a qualified helper when using the system.
9.1.3.
Always use a lap belt if using the system with mobility equipment.
9.1.4.
Before use with mobility equipment, refer to your mobility equipment's owner guide for
acceptable ramp usage, including proper slope/incline, chair direction, etc.; never exceed its
recommendations.
9.1.5.
Before each use, check the system for worn, loose, or damaged parts. If you find any of these
conditions, do not use the system and contact your installer for service or repairs. Failure to
do so may result in serious injury.
9.1.6.
At all times, keep the system clear of dirt, leaves, and other debris that may accumulate on the
surface. Simply sweeping the ramp or using a garden hose will usually suffice, but, if needed, a
damp cloth or soft brush with soap and water can be used (avoid use of alkaline detergents).
9.1.7.
If tread surface is covered with ice and or snow, remove ice and or snow before use. Snow
accumulation should be shoveled, and the tread surface swept clean. Magnesium Chloride
may be used to melt snow or ice accumulation on the ramp; however, after the snow and or
ice threat has cleared, be sure to clean the tread surface with soap and water (avoiding
alkaloid detergents) to remove Magnesium Chloride residue. See ‘DEICING’ below for
additional information.
9.1.8.
Keep the system clear of debris and clutter. Do not use the system if walking surface is unsafe.
9.1.9.
Do not run, jump, or play on or around the system, including climbing on or between the
handrails.
9.1.10.
Do not use any part of the system to support planters, lights, decorations, etc.
9.1.11.
The system may be slippery in wet conditions; use caution as traction may be reduced.
10. DEICING
For the safety of all users, it is important to keep your system clear of snow, ice, and other debris.
Always follow the deicing agent manufacturer’s directions.
EZ-ACCESS will not be held responsible for any injuries or damages that arise from the information
provided. ALWAYS check with the deicing product’s manufacturer or your local supplier to
determine which method is best for your situation.
After the snow and or ice threat has cleared, be sure to clean the tread surface with mild soap and
water (avoid alkaline detergents) to remove deicing residue.
Sodium Chloride (salt) and Calcium Chloride are particularly damaging to newly poured
concrete. In addition, these chemicals should not be applied to brick or stone surfaces.
While care has been taken to ensure that the table below is accurate, the information shown is not
all-inclusive. Manufacturers of deicing products may make changes to their products as well as
recommended functions and usage requirements. The deicing method you choose should be
researched with your deicer supplier so you can determine which method is best for your situation.
The information below is taken from Fact Sheet 707, Cooperative Extension Service,
University of Maryland at College Park, University of Maryland Eastern Shore, and was up to
date at the time of this manual’s publication.
To Next Page
Loading...
Need help?
General
