Page 3 of 44
Warnings
Programmable control devices such as the EZ3-TouchPLC Modular units are not fail-safe devices and such as must not
be used for stand-alone protection in any application. Unless proper safeguards are used, unwanted start-ups could
result in equipment damage or personal injury. The operator must be made aware of this hazard and appropriate
precautions must be taken.
In addition, consideration must be given to the use of an emergency stop function that is independent of the EZ3-
TouchPLC Modular.
The diagrams and examples in this user manual are included for illustrative purposes only. The manufacturer cannot
assume responsibility or liability for actual use based on the diagrams and examples.
Trademarks
This publication may contain references to products produced and/or offered by other companies. The product and
company names may be trademarked and the sole property of their respective owners. AVG Automation disclaims
any proprietary interest in the marks and names of others.
Manual part number: EZ3-TouchPLC Modular
© Copyright 2019, AVG Automation All Rights Reserved
No part of this document shall be copied, reproduced, or transmitted in any way without the prior written consent of
AVG Automation. AVG Automation retains the exclusive rights to all information included in this document.
Designed, Built and Marketed by AVG
4140 Utica Ridge Rd. · Bettendorf, IA 52722-1327
Phone: 1-877-774-EASY · Fax: 1-877-775-EASY · www.ezautomation.net
EU Information
The EZ3 Series TouchPLC is manufactured in compliance with European Union (EU) Directives and carries the CE
mark. They been tested under CE Test Standard #EN55011, and is submitted for UL Certification. Products with CE
marks perform their required functions safely and adhere to relevant standards as specified by EU directives
provided they are used according to their intended purpose and that the instructions in this manual are adhered to.
The protection provided by the equipment may be impaired if this equipment is not used in accordance with this
manual. Only replacement parts supplied by AVG Automation or its agents should be used.
Technical Support
Consult Programming Software Help Directory. You may also find answers to your questions in the operator interface
section of our website @ www.ezautomation.net. If you still need assistance, please call our technical support at 1-
877-774-EASY or FAX us at 1-877-775-EASY.
SELV Circuits
All electrical circuits connected to the communications port receptacle are rated as Safety Extra Low Voltage (SELV).
Preventative and Maintenance Cleaning
No special preventative measurement is required.
To Next Page
Loading...
Need help?
General