FAAC B614 - Page 24

19 20
18
B614 22 732998 - Rev.A_DRAFT
2
2
21
1
3
6
5
Translation of the original instructions
ENGLISH
5. (18) Insert beam 1 in the lever.
!
To make the insertion of the beam easier, use a stand for
resting it at the end.
6. Line up the two holes underneath (slide the lower
edging temporarily to uncover the holes).
7. Fix the beam with screws 2, interposing the wash-
ers (reposition the lower edging).
8. (19) Insert cover 1 and fix it with screw2, inter-
posing the washer.
9. Insert the cover 3 at the end of the beam.
!
(20) Leave the beam supported to take the weight
until the assembly of the spring is complete.