FAAC E145S - Technical Specifications

E145S 6 532369 - Rev.A
Translation of the original instructions
ENGLISH
 1 Technical data E145S
Power supply voltage 90…260 V~ 50/60 Hz
Max power stand-by: 4 W
sleep: <2 W
Max. motor power 800 W total
Max. accessories load 24 V
"
500 mA
Bus 2easy 500 mA
Max. flashing light load 230 V~ 60 W max
Ambient operating temperature -20…+55 °C
3.5 TECHNICAL SPECIFICATIONS
E145S It is an electronic board designed to control one
or two 230 V~ motors with an overall power of 800
W (800 W refers to the sum of the loads connected to
the two motor outputs irrespective of how they are
distributed).
Switching power supply The switching power supply
reduces power consumption in stand-by, keeps the
output voltage stable even in the event of fluctuations
in the mains supply and works over a wide range of
input voltages.
Programming There are two menus for programming
from the board, via display and dedicated but-
tons: BASIC and ADVANCED.
In addition, remote programming from Simply Connect
provides a larger number of options, including upload-
ing / downloading the programming and updating
the board FW.
Simply Connect This CLOUD platform allows remote
communication with the automation, with modes spe-
cific for the installer or user. Simply Connect requires
an accessory connectivity module to be plugged in,
which is chosen according to technology used:
- XMB (GSM for mobile, Bluetooth Low Energy
technology)
- XWBL (WiFi, LAN, Bluetooth Low Energy technol-
ogy)
Bus 2easy It is possible to connect FAAC Bus 2easy
devices (photocells, sensitive edges and control de-
vices) to the E145S board.
Radio system The E145S is fitted with an integrated
two channel decoding system (Omnidec) that can
memorise, various types of Faac radio codes by simply
adding a radio module.
In addition, a quick insertion (5 pin) connector for FAAC
radio/decoder boards is available.
Sensitive edges The E145S has two inputs for connect-
ing NC or 8.2 KΩresistive sensitive edges. Up to two
8.2 KΩ resistive sensitive edges can be connected in
parallel to each input.
Encoder An accessory encoder can be connected (e.g.
SAFEcoder BUS 2easy) or integrated in the operator
(e.g. S800 ENC). The electronic board detects the
angular position and the speed of movement of the
leaf via the encoder and is able to detect the presence
of an obstacle.
Limit switches The E145S has inputs for opening and
closing limit switches that can be used to start the
slowdown or stop the gate.
End of travel slowdown The E145S can slow down the
movement close to the open and closed positions, in
order to limit inertial forces and reduce the vibrations
of the gate when it is stopping.