FAAC E145S - System Diagnostics and Error Codes

E145S 30 532369 - Rev.A
Translation of the original instructions
ENGLISH
 9 Status of the LEDs
LED colour meaning
 
OPEN A red Total motion command active not active
OPEN B red Partial motion command active not active
STOP red Stop command not active active
FSW CL red Closing photocell not active active
FSW OP red Opening photocell not active active
EDGE1 red Opening sensitive edge not active active
EDGE2 red Closing sensitive edge not active active
FCA1 red Opening limit switch Leaf1 not engaged engaged
FCC1 red Closing limit switch Leaf1 not engaged engaged
FCA2 red Opening limit switch Leaf2 not engaged engaged
FCC2 red Closing limit switch Leaf2 not engaged engaged
5V blue Power supply 5 V on off
24V blue Accessories power supply 24 V
"
on off
ERROR red Error signalling error no errors
BUS red Bus 2easy devices
see § Bus 2easy devices
BUS MON green Bus 2easy devices
USB red USB pen drive inserted (*) Installed not inserted
RADIO1 red Channel 2 Omnidec (*) active not active
RADIO2 red Channel 2 Omnidec (*) active not active
(*) Additional LED status or meanings are shown in the section on the accessory to which it refers.
10. DIAGNOSTICS
10.1 FIRMWARE VERSION
The firmware version is show on the display for 5
seconds each time it is switched on.
10.2 CHECKING THE MOVEMENT
Access basic programming and use function M2 for
Leaf2 (displayed if the automation is configured for 2
leaves) and function
M1 for Leaf1.
1. The function displays
--.
2. Use buttons
++ and
--
in dead man mode. One of
the expected commands must be given:
++ to OPEN (oP on the display)
--
to CLOSE (cL on the display)
Otherwise, temporarily disconnect the power supply
and invert the phases (OP/CL) of the motor.
10.3 AUTOMATED SYSTEM STATUS
The display, other than when in the programming
menu, provides information regarding the status of
the automation system ( 8).
 8 Automated system status
00
CLOSED
01
OPEN
02
STATIONARY THEN OPENS
03
STATIONARY THEN CLOSES
04
IN PAUSE
05
OPENING
06
CLOSING
07
FAILSAFE IN PROGRESS
08
CHECK Bus 2easy
09
PREFLASHING BEFORE OPENING
10
PREFLASHING BEFORE CLOSING
11
EMERGENCY OPEN
12
EMERGENCY CLOSE
HP
HOLD POSITION
.
(flashing) SLEEP
10.4 LEDS CHECK
 9 bold indicates the condition of the LEDs with the
board powered, the gate at its halfway position and no
connected device active (=on ; =off).