FAAC E145S - Simply Connect Module Integration

E145S 28 532369 - Rev.A
XMB GSM Mobile, Bluetooth Low Energy
XWBL WiFi, LAN ethernet, Bluetooth Low Energy
7
LOCKMAIN
LAMP
M1 M2 IN1 IN2 IN3 IN4 IN5
F+/R1 -/R2
M M
230V~
60W max
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 27 28 29
23
24
25
26
RADIO
RP/DEC
2EASY
CONNECTIVITY
CR2032
USB-A
EDGE1
OUT1 COM OP CL PE N L COM
OP-A
+24V +24V
- - - -
OP-B STOP FSW CL FSW OP
OP CL OUT2
LOCK1 LOCK2 EDGE2
FCC2
FCA2
FCC1
FCA1
230V~
C C
Translation of the original instructions
ENGLISH
8.6 SIMPLY CONNECT
!
To safeguard people and property, the automation
must be supervised and there must be not be any
unauthorised persons present for the entire duration
of operations carried out remotely (SETUP and/or
modifications to operating parameters).
i
Simply Connect requires E145S firmware version FW
4.0 or later.
When programming is taking place via Simply Connect,
programming via the board is inhibited.
1. With the board switched off, insert the module into
the dedicated plug in connectors.
2. With the board powered, check the signalling LEDs
(see module instructions).
3. Enable communication by assigning a channel
(CH) to the board.
Basic programming, function
C C:
1 CH 1, 2 CH 2, 3 CH 3, 4 CH 4
IMPORTANT: if the automation is in a Multicom net-
work, assign a different channel compared to the other
boards that are connected.
4. Install the Simply Connect installer App (supplied
with the module).