Mt740/745, 741/746/En/Rev. 002/12/97 * 901.742 002
BEISSBARTH MT 740/ 745, 741/ 746
9-3
6.Turn the wheel as indicated by the red
arrow until a green bar appears.
- Mark the tyre perpendicularly above the
wheel-balancing shaft (twelve o'clock
position).
- Unseat the bead on the fitting device and
turn the tyre on the rim so that the mark is
flush with the valve.
7.Inflate the tyre to the prescribed pressure,
secure to the balancing flange again and
screw in the wheel, with the valve vertically
beneath the wheel-balancing shaft (6 o'clock
position).
8.Press OK key (13).
The next step "START" appears on the
screen and flashes.
- Start machine.
After braking the wheel, the reduced
matching static wheel component appears
in yellow figures in the top right-hand
section of the screen.
The imbalance displays in grams for the
outer and inner level will appear.
- Attach the balance weights.
Note:
Matching can be interrupted at any time by
pressing the matching key (8).
To record the initial and final matched values
for the static wheel component on the tape
printer, press the printer key before starting
the matching procedure.
To Next Page