October 2000 Important Safety Information: Important! 7
SIEMENS CONTROL
Operator Manual
Fadal
verify the current RPM commanded in the control before starting the
spindle.
13) SECURE TOOLS PROPERLY IN THEIR HOLDERS.
14) SECURE WORK. Use common machining practices for holding
(fixturing) material to be machined.
15) REMOVE ALL TOOLS FROM THE SPINDLE AND TOOL CHANGER before
servicing and changing accessories such as tooling, fixtures, indexers, the
tail stock of a fourth axis and any fourth axis or fourth-fifth axis
combination, etc.
16) ALWAYS DEBUG A NEW PROGRAM before running it in the AUTO
mode. (See DEBUG PROGRAM in the User’s Manual.)
17) The machine tool MUST be connected to a grounded, metal,
permanent wiring system, or to a system having an equipment-grounding
conductor.
18) DO NOT OPERATE THE MACHINE IN AN UNSAFE ENVIRONMENT. Do
not use the machine in damp or wet locations, or expose to rain. Keep the
work area well lighted.
19) DO NOT FORCE TOOL. Tools are designed to perform properly and
safely at proper rates. Keep tools sharp.
20) USE THE CORRECT TOOL. Do not attempt to use tools or attachments
to perform a job for which they were not designed.
21) DON’T OVERREACH. Keep proper footing and balance at all times.
Use a steady object for support when reaching over the machine.
22) REDUCE THE RISK OF UNINTENTIONAL STARTING. Power off the
machine at the main disconnect switch and use the proper lockout/tagout
procedures while working within the chip enclosure, or when there is
potential for a release of energy.
23) POWER OFF THE MACHINE AT THE MAIN DISCONNECT SWITCH AND
LOCK OUT WHEN WORKING INSIDE ANY OF THE ELECTRONIC CABINETS.
24) USE RECOMMENDED ACCESSORIES. Refer to the User’s Manual for
FADAL recommended accessories. Unapproved accessories increase the
risk of injury.
To Next Page
Loading...
Need help?
General
