44 Fadal/Sinumerik 810D CNC: Definition of Offsets October 2000
SIEMENS CONTROL
Operator Manual
Fadal
Using the ZERO OFFSET Soft Key to set the Base and Zero
Offsets
1) The ZERO OFFSET soft key is accessed from the main manual display. To
get to the main manual display press the OFFSET PARAM hard key.
2) Press the ZERO OFFSET soft key. The zero offsets table is displayed.
3) Use the cursor key pad arrows to move to the desired fields in the table
for editing.
Page Down Indicator
Further Axes
To Next Page
Loading...
