FADAL VMC 3020 - Using the SET BASE Soft Key to Set the Base Offset

October 2000 Fadal/Sinumerik 810D CNC: Definition of Offsets 33
SIEMENS CONTROL
Operator Manual
Fadal
Using the Set Base Soft Key to set the Base Offset
Note:
Only the X, Y and Z Axes can be set with this method. The Base Offset for
the A and B axes must be set directly in the Zero Offset screen.
1) The SETBASE soft key is accessed from the main manual display. To get
to the display press the MACHINE MANUAL soft key.
2) Press the SETBASE soft key. The X-axis will be highlighted in red.
3) Press the MPG hard key to activate the MPG hand wheel.
4) Select the X-Axis with the axis selector switch.