EN
X
Using the other control key on the digital control unit, set the servo to
its second hold position (hold position “green”).
X
Using the temporary »+« and »-« keys on the digital control unit, preset
the second hold position of the servo (hold position “green”).
X
Save both hold positions of the servo by moving to and fro three times
between the hold positions by means of the control keys, without chang-
ing the presettings.
The servo moves to and fro between both preset hold positions.
X
Using the temporary »+« and »-« keys on the digital control unit, pre-
set the motion rate of the servo.
X
Press on one of the two control keys.
The presettings are saved.
The LED of the programmed servo port goes out.
»Prog« LED flashes at lower heart rate.
To Next Page
Loading...
