EN
Synopsis of all configuration variables
CV Description Range Default
setting
112 Software version - varying
113 Manufacturer’s code (Manufacture ID) - 85
119 Decoder configuration 0-15 15
Bit0 = 1: Voltage at output 1 is
always switched on
Bit0 = 0: Voltage at output 1 is
switched on only when
servo is in motion
Bit1 = 1: Voltage at output 2 is
always switched on
Bit1 = 0: Voltage at output 2 is
switched on only when
servo is in motion
Bit2 = 1: Voltage at output 3 is
always switched on
Bit2 = 0: Voltage at output 3 is
switched on only when
servo is in motion
Bit3 = 1: Voltage at output 4 is
always switched on
Bit3 = 0: Voltage at output 4 is
switched on only when
servo is in motion
Bit4: Is not used
Bit5: Is not used
Bit7 = 0: DCC operation
Bit7 = 1: Motorola operation
To Next Page
Loading...
