Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 14 of 41
1) Connected to the telephone line (analog line, not ISDN)
2) Connected to the alarm button (Normally Closed or Normally Open), and
3) Set the device in programming mode.
Programming can be initiated approximately 20 sec. after the telephone has been connected
to the telephone line. Upon completion of each programming sequence a 4-tone confirms that
the telephone has accepted the programming. If no button is pushed during a time lapse of 30
sec. programming mode is automatically deactivated.
Important! The telephone number of Alarm Receiver 1 must be programmed to make an
alarm. Alarm Code 1 is default ‘1’ but must be programmed if the alarm is sent to an alarm
central.
6.2 Activation of programming mode
6.2.1 First time used of if unit is powerless
Remove the 8-pol connector and fasten the alarm button cords and telephone line cords.
Press down
and fasten the screw connector. The Fältcom ECII® Flex will automatically go
into programming mode. Once programming mode is entered this is confirmed by a tone in
the loudspeaker. This can also be used it the Fältcom ECII® Flex in operation; remove the
connector and wait 10 seconds for the unit to loose all power. Press down
and fasten the
screw connector again.
6.2.2 Reprogramming an Fältcom ECII® Flex
Press
and the alarm button simultaneously. Press for the same time as the selected time
for the alarm button, the default setting is 5 seconds. Once programming mode is entered this
is confirmed by a tone in the loudspeaker.
6.2.3 Reprogramming from phone
Call the telephone number to which the Fältcom ECII® Flex is connected and wait for the de-
vice to answer. The Fältcom ECII® Flex will first answer with a modem tone and then switch
to a 3-tone message; please view section Calls to a lift phone for more information. Press
#<ID>, default is 1. Wait for the 3-tone message, then program the PIN CODE. Default code
is 1111.
From phone:
# < PIN CODE> #
6.2.4 Indication and exit
The yellow and green LEDs will flash alternately when the Fältcom ECII® Flex is in program-
ming mode. Programming mode is deactivated automatically after 30 seconds if no key is
pressed. Note that some exchanges (mainly ISDN) sometimes disconnect the lift phone after
a shorter time. All programming must then be done at a different location. Normal alarms are
not affected by this.
You can also leave programming mode manually by pressing:
From keypad:
From phone:
000 #
To Next Page
Loading...