FältCom ECII Flex - End-of-alarm Function; 6.23 End-of-alarm; End-of-Alarm Activation and Type Setting

Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 31 of 41
The 6 hour open magnetic switch will use the default alarm type specified for the magnetic
switch function. To program another alarm type for the 6 hour open magnetic switch, first use:
From keypad: < alarm type >
From phone:
 620  < alarm type > #
Then activate the 6 hour open magnetic switch by programming:
From keypad:
From phone:
 621 #
The 6 hour open magnetic switch can be deactivated and alarm type reset, the magnetic
switch will be turned off, use:
From keypad:
From phone:
# 621 #
It is also possible to send an end-of-alarm using the keypad or a telephone. The call will be
made after leaving programming mode. The alarm can be sent using:
From keypad:
From phone:
 610 #
6.23.1 End-of-alarm receiver
End-of-alarms can be sent to a separate alarm receiver different from alarm receiver 1. If no
specific alarm receiver is programmed for End-of-alarm the alarms are sent to Alarm receiver
1.
From keypad:
<Telephone number (max 20 digits)>
From phone:
 640 <Telephone number (max 20 digits)> #
And to set a specific End-of-alarm code use
From keypad:
<Code (max 10 digits)>
From phone:
 641  <Code (max 10 digits)> #
If no End-of-alarm code is specified the Fältcom ECII® Flex will use the Alarm code 1.
Position of magnet switch