FältCom ECII Flex - Programmable Alarm Types; 6.21 Programmable Alarm Types

Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 28 of 41
From keypad:
From phone:
# 510 #
Return to the yellow/green flashing sequence by programming:
From keypad:
From phone:
 510 #
6.21 Programmable alarm types
When sending an alarm to an alarm receiver using the CPC protocol the alarm will be identi-
fied by the alarm code and alarm type. The alarm code specifies the location of the device
and the alarm type specifies the type of alarm that is being sent. The alarms can be of differ-
ent types but they all have the same alarm code. For the Fältcom ECII® Flex the default
alarm types are:
Alarm input
Alarm type (decimal)
Input 1
10
Input 2
10
Input 3
10
Test alarm/routine call
26
Battery alarm
17
Battery reset alarm
12
End-of-alarm (magnet)
28
Info alarm
89
Programmable alarm type alarm input 1
The normal alarm type 10 (0Ah) for emergency alarms may be mapped to another alarm type
where XX represents an alarm type between 00 and 99. The alarm type is changed with the
sequence:
From keypad:
<XX>
From phone:
 600  <xx> #
To reset the alarm type to the default value, enter:
From keypad:
From phone:
# 600 #
Programmable alarm type alarm input 2
Same functionality as for alarm input 1. Changed by:
From keypad:
<XX>