FältCom ECII Flex - Alarm Protocol; Dial Tone Detection; Speech Messages

Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 32 of 41
6.24 Alarm protocol
The CPC protocol is the default protocol used in Fältcom ECII® Flex. An alternative protocol
P100 is also available. This is activated by programming:
From keypad:
From phone:
 060 #
To return to the CPC protocol:
From keypad:
From phone:
 061 #
6.25 Dial tone detection
Fältcom ECII® Flex has a function which makes it possible to first wait for a dial tone before
the call out sequence starts. In default mode the Fältcom ECII® Flex waits 3 seconds and
then initiates the call. If dial tone detection is activated the Fältcom ECII® Flex will require a
425 Hz dial tone in order to initiate the call.
Dial tone detection is activated with:
From keypad:
From phone:
 040 #
To deactivate the dial tone detection:
From keypad:
From phone:
# 040 #
6.26 Speech messages
It is possible to record two different speech messages that can be played. One in the loud-
speaker of the Fältcom ECII® Flex to inform and calm the passengers in the lift and one to
the receiver to identify the originating location of the alarm call. Each message can be 10
seconds long.
Speech message 1; for the cabin
This message is activated and played one time in the lift when the alarm is activated.
Recording of message 1:
From keypad:
< wait for tone; read message. Max 10 seconds >
From phone:
 410  < wait for tone; read message. Max 10 seconds > #