Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 33 of 41
Listening to message 1:
From keypad:
From phone:
410 #
Deleting message 1:
From keypad:
From phone:
# 410 #
Note: When downloading a message using the Flex Programmer SW; the message must be
smaller then 128 kB. This is the allocated size in Flex memory.
Speech message 2; for the alarm receiver
This message is played in the receiving telephone before the alarm call has been acknowl-
edged by the alarm receiver. It is stopped by pressing any digit on the receiver telephone. For
simplified and disconnected acknowledge the message 2 is only played once. The receiver
can repeat the message 2 at any time during the call by pressing ‘1’ on the telephone hand-
set.
Recording of message 2:
From keypad:
< wait for tone; read message. Max 10 seconds >
From phone:
420 < wait for tone; read message. Max 10 seconds > #
Listening to message 2:
From keypad:
From phone:
420 #
Deleting message 2:
From keypad:
From phone:
# 420 #
Note: When downloading a message using the Flex Programmer SW; the message must be
smaller then 128 kB. This is the allocated size in Flex memory.
To Next Page
Loading...
