Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 36 of 41
in the chain. Note that #1 must be pressed by the caller even if only one lift phone is
mounted. The Fältcom ECII® Flex will reply with another 3-tone message indicating
the correct device has answered the call.
4. Press 4 to activate voice connection.
5. Press 5 to terminate a possible active alarm mode. The call is then disconnected.
6. Press 7 to listen in simplex mode.
7. Press 8 to speak in simplex mode.
8. Press 3 to activate the speaker and microphone in the Speech Unit (if connected).
Press 3 again to go back to the Fältcom ECII® Flex speaker and microphone.
9. Press 0 to disconnect the call.
7.8.2 Single unit on the line
If the function 142 has been programmed the Flex will answer the call and go straight to
conversation mode. The Fältcom ECII® Flex will behave differently depending on the
acknowledgement settings:
For normal acknowledge (default setting) and 320 go through steps 4 – 8 above.
For acknowledgement functions 321 and 323 the Fältcom ECII® Flex will automatically go
to duplex conversation on incoming calls. End the call by hanging up or press on the re-
ceiver handset.
7.9 Volume control
Adjust the volume in the Fältcom ECII® Flex speaker by using a screw driver to turn the vol-
ume control. The control is located on one of the sides of the Fältcom ECII® Flex.
- To increase the volume; turn the control counter clockwise and
- To decrease the volume; turn the control clockwise.
The Fältcom ECII® Flex will set the volume automatically as the volume control is turned. The
new volume will be used in all following calls.
Please note that previous versions of the Fältcom ECII® Flex have a different procedure for
the volume control:
To change the volume during a call on older versions then SW 0.2.4:
- Turn the volume control
- Ask the receiver to press ‘4’ on the receiver handset
- The new volume is set in the Fältcom ECII® Flex
To Next Page
Loading...