If you use static mode, you need set it.
IP Address Input the IP address distributed to you.
Netmask Input the Netmask distributed to you.
Gateway Input the Gateway address distributed to you.
DNS Domain
Set DNS domain postfix. When the domain which you
input can not be parsed, gateway will automatically add
this domain to the end of the domain which you input
before and parse it again.
Primary DNS Input your primary DNS server address.
Alter DNS Input your standby DNS server address.
If you uses PPPoE mode， you need to make the above setting.
PPPoE Server It will be provided by ISP.
Username Input your ADSL account.
Password Input your ADSL password.
Notice:
1）Click “Apply” button after finished your setting, IP gateway will save the
setting automatically and new setting will take effect.
2）If you modify the IP address, the web will not response by the old IP
address. Your need input new IP address in the address column to logon
in the web.
3）If networks ID which is DHCP server distributed is same as network ID
which is used by LAN of system, system will use the DHCP IP to set WAN,
and modify LAN’s networks ID(for example, system will change LAN IP
from 192.168.10.1 to 192.168.11.1) when system uses DHCP client to get IP
in startup; if system uses DHCP client to get IP in running status and
network ID is also same as LAN’s, system will refuse to accept the IP to
configure WAN. So WAN’s active IP will be 0.0.0.0
To Next Page
Loading...
