MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL
95
To configure the printer NIB in the CIS-4 configuration tool, follow the steps listed below:
1. Power up the system.
2. Connect the programming cable between the laptop and the NIB.
3. Right click on the printer node and choose the write command.
4. The LED on the NIB will flash briefly indicating the NIB has been configured.
Since the printer capability is always on, there is no need to configure it. Every panel, however,
has the capability to turn the printer off using the Tech menu < Network Setup. Once enabled,
everything will be printed to the network that is picked up by the printer node.
The printer is unsupervised.
Refer to the MPC-NET2 Owner’s Manual, P/N 315-049594, for more information.
To Next Page
Loading...
