MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL
54
PROGRAMMING THE CONTROL UNIT
KEYPAD PROGRAMMING
Customized programming of the control unit may be accomplished through the keypad in the
control unit. See the Faraday MPC-6000 / MPC-7000 / RND-2 Programmer’s Manual, P/N
315-049403FA, for detailed information of system programming.
PC PROGRAMMING
Programming the panel may also be done by a temporary connection to the programming port
with a computer. This is a convenient method to program the panel.
The Faraday CIS-4 software allows programming the control unit by connection to a Personal
Computer (PC) with an EIA-232 serial port. This allows ease of operation by preparing the
program in advance and downloading to the control unit in a simple, rapid operation.
PROGRAMMING SECURITY
The following levels of security protect the system from unauthorized use:
User – Locked Door
Maintenance – Locked Door and 4-digit Maint. Password
Technician – Locked Door and 6-digit Tech Password
The User Level is also accessible from the Remote LCD Annunciators.
To Next Page
Loading...
