OPERATION
General information
• Only use the machine to lift personnel and their tools and equipment.
• Do not operate a faulty machine. Should a fault occur, switch off the
machine.
• Do not move the control switches abruptly or levers from one position to
the opposite one, going through the neutral position; always move the
switch to the neutral position before moving it in the position of the next
function. Operate the controls by exerting slow and even pressure.
• If there are people on the work platform, allow personnel to operate the
machine from the ground exclusively in the event of an emergency.
• Completely lower the extending structure and disconnect the power
supply before leaving the machine unattended.
• When welding is carried out from the machine, take precautions to
protect all machine components from contact with sprays generated by
welding or with molten metal.
• Ensure the power tools are stored correctly, avoiding to let them hang
by the cords in the machine's work area.
• (In case of a battery powered machine) Charge batteries in a well-
ventilated area.
Fall hazard
• Before using the machine, ensure all rails and gates are secured in the
correct position.
To Next Page
Loading...