SECTION 4. CONTROLS, WARNING LIGHTS AND
MACHINE OPERATION
INTRODUCTION
ATTENTION
THE MANUFACTURER DOES NOT HAVE ANY DIRECT CONTROL OVER
MACHINE APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
REQUIRED TO COMPLY WITH THE CORRECT SAFETY PROCEDURES.
The ZP model lifting equipment are electric machines fitted with an elevating
work platform, assembled on a lifting mechanism with aluminium mast.
The lifting device is INTENDED TO MOVE PERSONS TO THEIR WORK
POSITIONS FROM WHERE THEY CAN CARRY OUT THEIR TASKS FROM THE
WORK PLATFORM.
The main control station is located on the work platform. The operator can
lift and lower the work platform from the work platform control console (the
machine is not equipped with self-propelling, therefore shifting is by manual
pushing, allowed only when the work platform is at the lowest position). If the
operator on the work platform is unable to lower it, the ground control
station's controls must be used when performing machine maintenance or in
the event of emergency. Vibrations generated by the machine do not pose
any danger for the operator who is on the work platform. The level of
continuous sound pressure (A measurement) on the work platform is less
than 70 db (A).
To Next Page
Loading...