01-06-2022 4812134740EN 19
High pressure cleaning
Do not spray directly into electrical components.
.
Do not use a high-pressure water jet on the
instrument panel/display.
Detergent that can destroy electrical parts, or
which is conductive, must not be used.
In certain cases there is an electrical control lever
and associated electronic control unit (ECU) in
the engine compartment, which must not be
washed with a high-pressure jet or with any water
at all. It is sufficient to wipe these off.
The same applies to the engine electronic control
unit (engine ECU).
Place a plastic bag over the fuel filler cap and secure
with a rubber band. This is to avoid high pressure
water entering the vent hole in the filler cap. This could
cause malfunctions, such as the blocking of filters.
Place a plastic bag over the exhaust pipe and secure
with a rubber band to avoid water in the muffler.
Never aim the water jet directly at the fuel tank
cap, or into exhaust pipe. This is particularly
important when using a high-pressure cleaner.
Fire extinguisher
If the machine catches fire, use a ABC-class powder fire
extinguisher.
A BE-class carbon dioxide fire extinguisher can also be used.
Roll Over Protection Structure (ROPS), ROPS-
approved cab.
If the machine is fitted with a Roll Over Protective
Structure (ROPS, or ROPS-approved cab), never
carry out any welding or drilling in the structure or
cab.
Never attempt to repair a damaged ROPS structure
or cab. These must be replaced with a new structure
or cabs.
To Next Page
Loading...
