13 4812134740EN 01-06-2022
Safety - General instructions
(Also read the safety manual)
1. The Operator must be familiar with the contents of the OPERATION section
before starting the roller .
2. Ensure that all instructions in the MAINTENANCE section are followed.
3. Only the operator is allowed to be on the roller. Remain seated at all times when
operating the roller.
4. Never use the roller if it is in need of adjustment or repair.
5. Only ascend and descend the roller when it is stationary. Use the intended
footsteps, grips and rails. Always use the three point grip (both feet and one hand,
or one foot and both hands) when ascending and descending the machine. Never
jump down from the machine.
6. Dynapac always recommends mounted ROPS (Roll Over Protective Structure), or
a ROPS- approved cab and seat belt usage.
7. Drive slowly in sharp bends.
8. Avoid driving across slopes. Drive Straight up or straight down the slope.
9. Never operate with the drum outside the edge, the substrate might not have full
bearing strength, or the edge is close to a slope. Avoid operating close to edges
and ditches and the like as well as on poor ground conditions that jeopardizes the
bearing strength and capacity to support the roller.
10. Make sure that there are no obstacles in the direction of travel, on the ground, and
in front of or behind the roller or overhead.
11. Drive particularly carefully on uneven ground.
12. Keep the roller clean. Clean any dirt or grease that accumulates on the footsteps
or operator platform to avoid slipping risk. Keep al signs and decals clean and
legible.
13. Safety measures before refuelling:
- Stop the engine;
- Do not smoke;
- No naked flames in the vicinity of the roller
- Earth the filling equipment nozzle by keeping it in contact to the tank opening to
avoid sparks.
To Next Page
Loading...
