Fayat Group Dynapac CA30D - Service and Maintenance Point; Every 10 Hours of Operation (Daily); Every 50 Hours of Operation (Weekly); After the First 50 Hours of Operation

Maintenance – Planned maintenance
01-06-2022 4812134740EN 81
Service and maintenance point
Check the Dobbs meter on the machine to know
what type of maintenance is needed.
Every 10 hours of operation (Daily)
Refer to the contents to find the page number of
the sections referred to !
Pos. in fig
Action
Comment
Before starting up for the first time on that day
13
Check the scraper setting
1
Check for free circulation of cooling air
35
Check coolant level
Refer to the engine manual
3
Check the engine oil level
Refer to the engine manual
28
Refuel
5
Check the hydraulic reservoir level
Test the brakes
17
Grease the steering cylinder bearings
Fill the urea tank
Every 50 hours of operation (Weekly)
Refer to the contents to find the page
number of the sections referred to!
Pos. in fig
Action
Comment
Check that hoses and couplings are not leaking
4
Inspect/clean the filter element in the air cleaner
Replace as required
16
Lubricate the articulation
17
Check that the guiding cylinders are tight
19
Check the wheel-nuts are tightened
20
Check the tire pressure
Check the air conditioning
Optional
After the FIRST 50 hours of operation
Refer to the contents to find the page
number of the sections referred to !
Pos. in fig
Action
Comment
8
Change the hydraulic fluid filter
21
Change oil in rear axle differential