Fayat Group Dynapac SD2500C - Page 194

D 22 22
- (2) Left conveyor speed (%) display and adjustment parameters
- (3) Right conveyor speed (%) display and adjustment parameters
- (4) Left auger speed (%) display and adjustment parameters
- (5) Right auger speed (%) display and adjustment parameters
- (6) Nominal tamper speed (n/min) display and adjustment parameters
- (7) Nominal vibration speed (n/min) display and adjustment parameters
A
Tamper and vibration range depending on screed type.
A
If the settings are not saved, an adjusted parameter remains valid until another
course thickness is chosen. This also applies when restarting the vehicle.
7
6
4
32
5
1
1a 1b 1c 1d 1e