Fayat Group Dynapac SD2500C - Observe indicator lamps; Engine coolant temperature check (A); Battery charge indicator lamp (B); Diesel engine oil pressure indicator lamp (C)

D 41 13
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
For further possible faults, see Engine's operating instructions.
Engine coolant temperature check (A)
Lights up when the engine temperature is outside of the permissible range.
m
Stop the paver finisher (drive lever to the centre position), let the engine cool down
while idling.
Determine the cause and correct it if necessary.
A
The engine performance will be throttled down automatically.
(Driving mode remains possible).
After cooling down to normal temperature, the engine will run with full performance again.
Battery charge indicator lamp (B)
Must go out after starting when the engine revs up.
m
If the lamp does not go out or lights up during operation: Briefly rev up the engine.
Switch off the engine and determine the fault if the lamp does not go out.
For further possible malfunctions, refer to the section "Malfunctions".
Diesel engine oil pressure indicator lamp (C)
Must go out at the latest 15 seconds after starting.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.