6
Screed control with paver finisher stop / in paving operation
(screed stop / paving stop / floating paving) .........................................29
Adjusting the pressure .........................................................................33
Setting pressure for screed control with paving stop + relieving: .........33
1.7 Interrupting/terminating operation ............................................................35
During breaks in paving (e.g. delay due to material trucks) .................35
During longer breaks (e.g. lunch break) ...............................................35
When work is finished ..........................................................................37
2 Malfunctions .............................................................................................38
2.1 Problems during paving ............................................................................38
2.2 Malfunctions on the paver finisher or screed ............................................40
E10 Set-up and modification ......................................................... 1
1 Special notes on safety ..............................................................................1
2 Distribution auger .......................................................................................2
2.1 Height adjustment ......................................................................................2
Grain sizes up to 16 mm ........................................................................2
Grain sizes > 16 mm ..............................................................................2
2.2 Mechanical adjustment
with ratchet (o) ............................................................................................3
2.3 Hydraulic adjustment (o) ............................................................................3
2.4 Height adjustment for large working widths / with brace ............................4
3 Auger extension .........................................................................................6
3.1 Mounting extension parts ...........................................................................7
Mounting the material shaft and auger extension ..................................7
Mounting the outer auger bearing ..........................................................8
Mounting the auger end bearing ............................................................9
3.2 Auger extension chart ..............................................................................10
Auger upgrading, working width 3.14 m ...............................................12
Auger upgrading, working width 3.78 m ...............................................12
Auger upgrading, working width 4.42 m ...............................................12
Auger upgrading, working width 5.06 m ...............................................13
Auger upgrading, working width 5.70 m ...............................................13
Auger upgrading, working width 6.34 m ...............................................14
Auger upgrading, working width 6.98 m ...............................................15
Auger upgrading, working width 7.62 m ...............................................16
Auger upgrading, working width 8.26 m ...............................................17
Auger upgrading, working width 8.90 m ...............................................18
3.3 Mounting the auger brace ........................................................................19
3.4 Aligning the auger ....................................................................................21
3.5 Material shaft, hinged ...............................................................................22
3.6 Hopper scraper .........................................................................................23
3.7 Crossbeam guide .....................................................................................24
4 Offsetting the screed ................................................................................25
5 Levelling ...................................................................................................26
5.1 Slope controller ........................................................................................26
5.2 Mounting the sensor arm ..........................................................................27
5.3 Mounting the grade control system ..........................................................27
5.4 Setting up the sensor arm ........................................................................28
To Next Page
Loading...
