C-320/C-320C and C-380/C-380C Technical Service Manual Revised 06/09
26
To replace the C-320C and C-380C basket full sensor:
1 Disconnect the basket full sensor wire connector from the PC board.
See the wiring diagram.
2 Remove the 2 screws that hold each basket full
sensor bracket to the cabinet shelf.
3 Remove the LED from each bracket. Note the
color of each LED.
4 Place the new LEDs in the brackets.
5 Insert each bracket through the opening in the ridge under the cutting
assembly on the cabinet shelf.
6 Reattach the brackets to the cabinet shelf. Make sure the two LEDs
are pointing at each other and adjust, if needed.
7 Plug the new basket full sensor wire connector into the PC board.
8 Place the sensor wires in the wire guides.
Replace Door Ajar Switch
A plastic plug on the cabinet door ts into an opening on the front of the
cabinet. The plug makes contact with the door ajar switch. If the switch is
working properly, you will hear a clicking sound from the switch when the door
is opened and closed. If the switch is not working, the door ajar troubleshooting
light will activate and the motor will not start until the door is closed properly.
Two screws hold the switch to a support on the cabinet shelf. Three wires
are hard-wired to PC board and to the switch. The entire PC board must be
replaced if this switch is defective (see the wiring diagrams).
To replace the door ajar switch:
1 Place the new switch in position on the ledge on
the cabinet housing.
2 Replace the 2 screws that hold the switch to
the cabinet. Make sure the blade on the switch
makes contact with the plastic plug on the door.
Reposition the switch if needed.
3 Place the wires securely in the wire guides
along the cabinet shelf.
DO THIS FIRST
Remove/Replace the
PC Board
TOOLS
Phillips screwdriver
C-320C/C-380C Basket
Full Senor Bracket
Door ajar switch
To Next Page
Loading...
