Ferroli Connect CRP - PACKAGE CONTENTS; CONNECT CRP DEVICE INSTALLATION; INSTALLING THE POWER SUPPLY PROVIDED; Auxiliary relay

78
EN
cod. 3542B380 - Rev 00 - 05/2022
2. PACKAGE CONTENTS
The package contains:
g. 2 a Connect CRP device g. 3 230 Vac - 24 Vdc power supply g. 4 screws/plugs kit g. 5 an instruction manual
3. CONNECT CRP DEVICE INSTALLATION
B
ATTENTION
•For proper control of the room temperature it is advisable to install the Connect CRC away from heat
sources, drafts or particularly cold walls (thermal bridges).
•In order to ensure electrical safety it is mandatory to secure the body of the device to the wall plate
•Installationandthe electricalconnectionmust bedonebyqualiedpersonnelincompliancewiththe
applicable laws.
•Before making any connections ensure that the power supply is disconnected.
The device is intended for mounting in standard flush-mounted (or wall-mounted) junction boxes with two or three
modules or directly on the wall.
To install the device, proceed as follows:
1. Detach the back panel of the Connect CRP by pressing the bottom catch, taking care not to damage the plastic.
g. 6
Avoid any pressure on the display, to prevent it from being damaged.