Ferroli Connect CRP - Page 84

84
EN
cod. 3542B380 - Rev 00 - 05/2022
Using the and buttons, select the “ZONES
MANAGER”menuandconrmwiththe
button.
I N S T A L L
I N S T A LLE R
ZON E S M A N AGER
A D D ZON E
D E L ETE ZON E
SEN SOR C A L IBR A TION
SYSTEM R ESET
g. 18
Using the and buttons, select the zone to be
conguredandthenconrmwiththe button.
I N S T A L L
I N S T A LLE R
CRP
BEDROOM
B A T HROOM
BEDROOM 2
KITCHE N
g. 19 - Example with 5 zones
On accessing this menu it will be possible to complete
thecongurationofthevariouszones.
MODIFY ZONE
INSTALLER
RF DEVICE
CLIMATIC CURVES
HYDRAULIC CONF
CHANGE NAME
g. 20
In particular, for each zone it will be possible to:
• Pair the zone to an RF device
MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE) >>
RF DEVICE >> PAIRING
NOTE To pair an RF device (
RF DEVICE
) see “ANNEX 1 - PAIRING AN RF DEVICE” on
page 106
• Set the "Climatic curves”
MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE) >>
CLIMATIC CURVES
NOTES Dene the climatic curves for both the HEATING and COOLING modes.
For correct setting of climatic curves (
CLIMATIC CURVES
) see “ANNEX 3 - CLIMATIC
CURVES” on page 107