Festo CMSX Series - Page 4

9.4.2 Overview of parameters - 2 PARA........................................................................... 29
9.4.2.1 CurTyp − Type of setpoint characteristic curve....................................................... 31
9.4.2.2 CurDef - Interpolation points.................................................................................. 32
9.4.2.3 TC-Mod − Tight-closing mode................................................................................. 33
9.4.2.4 TC-low – Lower tight-closing limit value................................................................. 34
9.4.2.5 TC-up – Upper tight-closing limit value.................................................................. 35
9.4.2.6 SL-Mod − Stroke-limitation mode.......................................................................... 35
9.4.2.7 SL-low - Lower stroke limitation value................................................................... 36
9.4.2.8 SL-up – Upper stroke limitation value.................................................................... 36
9.4.2.9 Deadbd – Deadband.............................................................................................. 36
9.4.2.10 P-Gain – P-proportion of the PID controller............................................................ 37
9.4.2.11 I-Gain – I-proportion of the PID controller.............................................................. 38
9.4.2.12 D-Gain - D-proportion of the PID controller............................................................ 38
9.4.3 Parameter overview - 3 IN/OUT.............................................................................. 39
9.4.3.1 AI-Typ – Type of analogue input............................................................................. 41
9.4.3.2 SR-Mod – Split range mode.................................................................................... 41
9.4.3.3 SR-low – Value of lower limit split range................................................................ 42
9.4.3.4 SR-up – Value of upper limit split range................................................................. 42
9.4.3.5 Dir-In – Setpoint value direction............................................................................. 42
9.4.3.6 DirOut – Position feedback direction...................................................................... 43
9.4.3.7 DI-Fct - Digital input function................................................................................. 44
9.4.3.8 DI-Log – Digital input logic..................................................................................... 45
9.4.3.9 DO1Fct – Digital output 1 function......................................................................... 45
9.4.3.10 DO1Log – Digital output 1 logic............................................................................. 45
9.4.3.11 DO2Fct – Digital output 2 function......................................................................... 45
9.4.3.12 DO1Log – Digital output 2 logic............................................................................. 46
9.4.3.13 ErrLog - Digital alarm output logic.......................................................................... 46
9.4.3.14 DO-Mod – Switching mode of digital outputs......................................................... 46
9.4.4 Parameter overview – 4 DIAG................................................................................. 47
9.4.4.1 V1CYCL, V2CYCL, V3CYCL, V4CYCL - number of switching cycles solenoid valve..... 47
9.4.5 Parameter overview – 5 INIT.................................................................................. 47
9.4.5.1 A-Init – Start automatic initialisation...................................................................... 47
9.4.5.2 Sensor – Check sensing range of the path/angle sensor.........................................48
9.4.6 Parameter overview - 6 DEVICE.............................................................................. 48
9.4.6.1 FReset – Reset parameters to factory setting......................................................... 48
9.4.6.2 LoadCf - Loading the last saved user-defined configuration....................................48
9.4.6.3 SafeCf - Saving the user-defined configuration...................................................... 48
9.4.6.4 BLight - Configuring the backlight of the digital display..........................................48
9.5 Schematic view of the mode of action of the parameters.............................................. 49
9.6 Commissioning positioner............................................................................................. 49
4 Festo — CMSX-...-C-U-F1-... — 2019-09d