Festo CMSX Series - 1 About this Document; Further Applicable Documents; 2 Safety; General Safety Instructions

1 About this document
1.1 Further applicable documents
All available documents for the product èwww.festo.com/pk.
2 Safety
2.1 General safety instructions
– Only use the product in original status without unauthorised modifications.
– Only use the product if it is in perfect technical condition.
– Observe labelling on the product.
– Only use the product in an industrial environment.
– The included cable fitting conforms to degree of protection IP65 if lines with the specified cross-
section are used è 14 Technical data.
– Seal unused openings with blanking plugs.
Return to Festo
Hazardous substances can endanger the health and safety of personnel and cause damage to the
environment. To prevent hazards, the product should only be returned upon explicit request by Festo.
– Consult your regional Festo contact.
– Complete the declaration of contamination and attach it to the outside of the packaging.
– Comply with all legal requirements for the handling of hazardous substances and the transport of
dangerous goods.
2.2 Intended use
The positioner is intended for regulating the position of the following actuators in process automation
systems:
– single-acting or double-acting quarter turn actuators with standardised mechanical interface
è 14 Technical data
– pneumatic actuators with connected external path/angle sensor
2.3 Training of qualified personnel
Work on the product should only be conducted by qualified personnel.
The specialized personnel must be familiar with the installation and operation of electrical and pneu-
matic control systems.
3 Additional information
– Accessories èwww.festo.com/catalogue.
About this document
Festo — CMSX-...-C-U-F1-... — 2019-09d6