Festo CP-FB13-E - General Information

2. Commissioning
2-5
Festo P.BE-CP-FB13-E-EN en 0112e
2.1.4 General information
FREEZE and SYNC
The operating modes F REEZE and SYNC are supported by the
CP system in accordance with EN 50170 (DIN 19245).
The access method for the FREEZE or SYNC command de-
pends on your controller. Please refer to the documentation
for your field bus module for further information.
Caution
Inthefollowingcases,theFREEZEorSYNCmodewillbe
automatically reset:
– when the CP system is switched on/off
– when the field bus module has stopped.
TheFREEZEmodewillalsobeautomaticallyresetinthe
following case:
– when the bus connection to the CP system is interrupted
(response monitoring active).